Safety ABS MCB Safety Lockout Devices

Safety ABS MCB Safety Lockout Devices
Product Details

Part No.: PIS 

Miniature Circuit Breaker Lockout
Pin in standard circuit breaker lockout
Mini circuit breaker lockout

  1. Made of engineering plastic strengthened nylon PA.

  2. Designed for breakers that have holes in the switch tongue.

  3. Quick and easy - just snap in place and applya safety padlock.

  4. Dual cavities accomodate different size switch tongues

  5. Can take padlocks with a shackle diameter up to 7mm.

  6. Available for single and multi-pole breakers.

SPECIFICATION:


Part No.

Description

POS

POS (Pin Out Standard), 2 holes required, fit up to 60Amp

PIS

PIS (Pin In Standard), 2 holes required, fit up to 60Amp

POW

POW (Pin Out Wide), 2 holes required, fit up to 60Amp

TBLO

TBLO (Tie Bar Lockout), no hole in breakers required

=2 拷贝


Cause of damage without energy isolation

Not stopping the machine or equipment

No energy is really cut off

It doesn't eliminate the residual energy

Accidentally turn on a device that has been turned off

The work site is not actually cleaned up before restarting


Pressure system test confirmation

Make sure the voltmeter is calibrated

Set the voltmeter range at the right voltage.

Test a strange voltage.

Check the hazard area with a voltmeter and confirm that it is zero voltage.

Measure the unfamiliar voltage again to confirm that the voltmeter is working properly.

Common system isolation principles

Hydraulic, pneumatic, steam drive - isolate all inlet and outlet lines

Engine drive - isolated fuel supply system and start-up system

Power drive - isolate the main circuit of the power supply

Isolate potential mechanical movement risks


Feedback