sales01@lockeysafety.com +86-133-96996593
Lockout Hasp To Clean The Care To Be In Place

Lockout Hasp To Clean The Care To Be In Place

Jun 26, 2017

Lockout Hasp to clean the care to be in place
Lock cap is an indispensable item in the day, its wide range of applications, variety of padlock style as much. Therefore, in order to adhere to the appearance of the lock cap and extend the life of the lock cap, in the usual use of the process, should pay attention to the appropriate cleaning and conservation.
  First, lock the cap to protect the appearance
  1, in the house during the decoration period, do not bring their own tape with a plastic contact with the appearance of the lock cap, seal the lock handle, panel, etc. to reveal some to avoid the lock parts of the surface treatment layer by the decoration with acidic or alkaline Materials and gas corrosion attack spots, blistering and even delamination, seriously affecting the appearance of the quality of locking cap.
  2, the normal use, if the dust, dry cloth can be used to clear, do not use detergent and other chemicals scrub. Otherwise, it will damage the protective film, causing fading. Do not scrub the lock body and handle with a damp cloth, because some metal raw material lock caps will rust; alloy raw material lock cap will wear off the coating, get pretty effect.
  Second, the lock cap performance protection
  1, in the course of use, timing (six months or once a year) or in the key plug is not smooth, in the keyhole with some graphite powder (pencil powder) from the smooth effect. Do not take any liquid oil as a smoothing agent to prevent grease from sticking to the marbles, so that the lock can not be rolled and can not be opened. When the door is closed, it is more laborious and can handle a small amount of pencil powder on the oblique tongue.
  2, close the door when the best holding the handle, the tongue into the lock body, close the door and then let go, do not force hit the door, otherwise it will reduce the life of the lock. Because the door and the door frame between the installed seal has a stretch effect, so when the lock with the handle or the key is tight, you can open the door with the door to open the door or pull the door to overcome the stretch, do not force the handle or key to open the door, Hand or key attack cracking.
Usually installed in the channel or bathroom lock cap anti-theft requirements are not too high, and the installation of the door lock door is the need to have a certain anti-theft effect, the lock body must be thick and solid,
  In the choice of the panel, according to their own special requirements to choose the padlock, plating surface decoration, style, function configuration.
  The surface of the panel without bruises, pattern meaning good, screw holes and screws in place, can not appear partial distortion of the phenomenon.
  And then to the details of the problem: liner and Lockout Hasp with the screw tight, the lock body does not allow the phenomenon of both sides of the swing.
  Before and after the panel on the good, the knob is open to open the phenomenon is not smooth, if there is not smooth phenomenon, loosen the screw, gently adjust with the glue hammer, transferred to the smooth so far!